How to Attach a Silicone Sleeve to Your memobottle

Quick answer

Start with the sleeve inside out, align the bottom corner, then roll it onto your memobottle from bottom to top for a smooth, bubble-free fit.

Step-by-step installation

1. Turn the sleeve inside out: Hold the sleeve with both hands and flip it so the printed or textured side faces inward. This exposes the smooth interior, making it easier to slide onto the bottle. Check that no part of the sleeve is twisted before proceeding.
2. Align the bottom corner: Place the inside-out sleeve over the bottom of your memobottle. Match the corner or curve of the sleeve to the corresponding corner of the bottle. For A7 bottles, align the flat edge with the bottle's base. If the sleeve seems misaligned, adjust before rolling—it is hard to correct later.
3. Roll the sleeve upward: Starting from the bottom, slowly roll the sleeve right-side out over the bottle. Use your thumbs to push the silicone upward while smoothing out any air bubbles with your fingers. Continue until the sleeve covers the entire body. Work slowly to avoid trapping air; small bubbles can be massaged out after full installation.
4. Check the fit and adjust: Once the sleeve is fully on, run your hand over the surface to ensure it is smooth and centered. The sleeve should not slide or rotate when you grip the bottle. If it feels loose, remove and reinstall following the same steps. A properly fitted sleeve stays put even when the bottle is full and handled normally.
5. Removal (when needed): To remove the sleeve, gently peel it off from the top edge. Work it downward slowly to avoid tearing. If the sleeve is stubborn, run it under warm water to soften the silicone slightly. Avoid using tools or excessive force—warm water is safer than prying.

Product facts

• A7 Silicone Sleeve - Pale Coral: The A7 Pale Coral Silicone Sleeve fits the A7 memobottle like a glove with a smooth matte finish and added thermal insulation. The precise fit means no slipping once installed, and the thermal insulation keeps your drink cooler longer.

  

• SLIM Silicone Sleeve - Cherry Blossom: The Slim Cherry Blossom Silicone Sleeve fits the Slim memobottle like a glove and offers drop protection and thermal insulation. Drop protection gives confidence for on-the-go use, and the thermal insulation helps maintain drink temperature.